Sable V6-3.0L VIN U (1999)
8. Install front safety belt buckle end to front seat track.
9. Position the seat and track assembly in vehicle.
10. Lift seat and track assembly high enough to permit the connection of the harness connectors, then connect wires.
11. Install the seat track-to-front floorpan retaining nuts and washers and/or bolts. Tighten the bolts to 19-26 Nm (14-19 lb-ft), inboard nut to 68-92
Nm (51-67 lb-ft) and outboard nut to 19-26 N-m (14-19 lb-ft).
12. Install four front seat track to floor insulators.
13. Connect battery ground cable.
14. Check front seat tracks for proper operation.
15. Check the restraint system for proper operation.
