Sable V6-3.0L VIN U (1999)
Brake Rotor
5. Remove two nuts retaining rear disc brake rotor to wheel hub. Remove rear disc brake rotor from wheel hub.
Installation
NOTE: Lubrication of hub pilot diameter with Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting
Ford specification ESE-M1C171-A or equivalent will ease future removal.
1. Install rear disc brake rotor on wheel hub. Install two new retaining nuts securely.
2. Install the rear disc brake caliper rear disc support bracket assembly with two new caliper anchor bracket bolts.
3. Tighten bolts to 87 - 119 Nm (65 - 87 ft. lbs.).
4. CAUTION: Failure to tighten lug nuts in a star pattern may result in high rotor runout, which will speed up the development of brake
roughness, shudder and vibration.
Install wheel and tire assembly on vehicle. Tighten lug nuts to 115 - 142 Nm (85 - 104 ft. lbs.) using Rotunda Accutorq Lug Nut Socket
164-R0303 or equivalent, on a 1/2 inch air impact wrench or use a torque wrench.
5. Lower vehicle.
