Sable V6-3.0L VIN U (1999)
INSTALLATION
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Connect air bag electrical connector to air bag sliding contact connector.
2. Position driver air bag module to steering wheel and secure with two screw and washer assemblies tightened to 10.2-13.8 Nm (90-122 lb-in).
3. Install two steering wheel spoke covers.
4. Reconnect battery ground cable.
5. Prove out air bag system.
6. Reprogram radio frequencies and set clock.
7. Prove out the air bag system.
