Sable V6-3.0L VIN U (1999)
NOTE: If auxiliary seat safety belts are present, they must be detached from rear seat safety bolts at the C-pillar.
2. Remove rear seat back.
3. Hold stud stationary at the hex collar which is located behind the quarter trim panel and remove quarter trim panel.
4. Remove bolt and D-ring assembly from C-pillar post.
5. Remove rear seat safety belt anchor plate-to-sill bolt.
6. Remove rear seat safety belt anchor bolt and safety belt retractor and tongue from C-pillar.
7. Remove seat belt webbing from quarter trim panel and roof side inner moulding.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten all anchor bolts to 34-46 Nm (25-33 lb-ft) for each mounting position.
4. Check the restraint system for proper operation.
Third Row Bench Seat - Retractor and Tongue (Wagon)
REMOVAL
1. Remove nut and guide from mounting stud.
2. Hold stud stationary at the hex collar which is located behind the quarter trim panel and remove quarter trim panel.
3. Remove stowage compartment door and hinge.
4. Remove bolt and seat belt anchor from rear floor pan.
5. Remove bolt and auxiliary seat belt and retractor assembly from vehicle.
6. Remove trim bezel.
7. Remove seat belt and webbing from quarter trim panel.
