Sable V6-3.0L VIN U (1999)
12.
If rear retractor(s) replacement is required, proceed as follows:
^
Remove the safety belt upper anchor bolt(s). See Figure 11.
^
Remove the safety belt retractor retaining bolt(s), then remove the safety belt retractor(s). See Figure 11.
^
Install the new safety belt retractor(s). Tighten the retaining bolt(s) to 40 Nm (30 lb-ft).
^
Install the safety belt upper anchor bolt(s). Tighten the anchor bolt(s) to 40 Nm (30 lb-ft).
13.
Install the lower quarter trim panel. Route the front seat safety belt through the trim panel before final installation.
14.
Install the upper quarter trim panel. Route the rear seat safety belt through the trim panel before final installation.
15.
Install the coat hook(s). Tighten the screw securely.
16.
Install the front seat safety belt upper anchor bolt(s). Tighten the anchor bolt(s) to 40 Nm (30 lb-ft).
17.
Install the backrest bolster. Tighten the retaining bolts to 11 Nm (8 lb-ft).
18.
Position the rear backrest cushion(s) to the upright position.
19.
Install the scuff plates(s).
20.
Install the rear seat safety lower anchor bolt(s). Tighten the anchor bolt(s) to 40 Nm (30 lb-ft).
21.
Install the rear seat cushion.
22.
Position both front seats in their original position.
Mustang Convertible
PASSENGER FRONT SAFETY BELT RETRACTOR
1.
Position both front seats fully forward.
2.
Remove the rear seat cushion.
