Sable V6-3.0L VIN U (1999)
17.
If outboard retractor(s) replacement is required, proceed as follows:
^
Remove the safety belt upper anchor bolt(s). See Figure 8.
^
Remove the safety belt retractor retaining bolt(s), then remove the safety belt retractor(s). See Figure 8.
^
Install the new safety belt retractor(s). Tighten the retaining bolt(s) to 40 Nm (30 lb-ft).
^
Install the safety belt upper anchor bolt(s). Tighten the anchor bolt(s) to 40 Nm (30 lb-ft).
18.
If center retractor replacement is required, proceed as follows:
^
Remove the center retractor retaining bolt.
^
Turn the retractor 90 degrees, then remove the center retractor. See Figure 8.
^
Install the new center retractor. Tighten the retaining bolt to 40 Nm (30 lb-ft).
19.
Install the package tray trim panel. Route the center safety belt through the trim panel before final installation.
20.
Install the center safety belt bezel into the package tray trim panel.
21.
Install the hi-mount stop lamp housing as follows:
^
Position the hi-mount stop lamp housing in the installed position. Make sure the retaining clips snap into position.
^
From the luggage compartment, install the housing retaining screws. Tighten the screws securely.
^
Install the hi-mount stop lamp bulb holder assembly. Make sure the holder snaps into position.
^
Connect the hi-mount stop lamp electrical connector.
22.
Position the module tray back in the installed position.
23.
Install the luggage compartment lower back panel.
24.
Close the trunk.
25.
Install the center safety belt lower anchor bolt. Tighten the anchor bolt to 40 Nm (30 lb-ft).
