Sable V6-3.0L VIN U (1999)
3. CAUTION: Do not hammer on the power steering oil reservoir.
Remove fiberglass power steering oil reservoir by twisting side-to-side and lifting.
4. Discard O-ring seal on power steering pump housing.
Installation
1. Install a new O-ring seal on power steering pump housing.
2. Apply petroleum jelly to power steering oil reservoir O-ring seal and inside edge of power steering oil reservoir. Do not twist O-ring seal.
3. Install power steering oil reservoir over power steering pump and align outlet fitting hole in power steering oil reservoir with hole in valve cover.
4. CAUTION: If valve is cocked, it may become stuck in the valve cover. Do not force valve forward. Forcing the valve may shear off metal
and carry the metal chips into the valve bore.
Place new O-ring seals on outlet fitting. Install flow control spring, flow control valve and outlet fitting into power steering oil reservoir and valve
cover. Tighten fitting to 33 - 47 Nm (25 - 34 ft. lbs.).
