Sable V6-3.0L VIN U (1999)
8.
Install a new nut. Tighten the nut to 80 Nm (59 lb-ft).
9.
Install the tie rod and a new nut. Tighten the nut to 55 Nm (41 lb-ft).
10.
Install a new cotter pin.
11.
Install the ABS sensor retaining clip and bolt. Tighten the bolt to 12 Nm (9 lb-ft).
12.
Install the front brake rotor.
13.
Install the brake caliper anchor plate and the anchor plate bolts. Tighten the bolts to 103 Nm (76 lb-ft).
14.
Install the brake pads, caliper and bolts. Tighten the bolts to 35 Nm (26 lb-ft).
15.
Install the caliper brake hose assembly and support bolt. Tighten the bolt to 15 Nm (11 lb-ft).
16.
CAUTION: Do not use power tools to install the stabilizer nut. Damage to the boot or ball joint can result.
NOTE:
To install the stabilizer nut use the hex holding feature to keep the stabilizer bar link ball joint from turning while installing the nut. Install a
new nut.
Tighten the nut to 80 Nm (59 lb-ft).
17.
Install the wheel and tire assembly.
18.
Lower the vehicle and install the wheel hub washer and nut. Tighten the nut to 250 Nm (184 lb-ft).
