Sable V6-3.0L VIN U (1999)
2. Tighten nut on checking tool.
Torque Converter Endplay Test
3. Mount Dial Indicator with Bracketry TOOL-4201-C or equivalent on end play checking tool.
With stylus contacting converter shell and with indicator at zero, lift on checking tool handles.
If indicator reading is above 1.27 mm (0.050 inch), replace the torque converter.
Service and Replacement Notes
The torque converter must be replaced if one or more of the following are true:
^
A converter malfunction has been determined based on the complete diagnostic procedures.
^
Converter stud(s), impeller hub or bushing is damaged.
^
Discoloration of the torque converter (due to overheating).
^
The torque converter is found to be out of specification, when performing one of the following converter checks.
^
One-Way Clutch Check
^
End Play Check
^
Stator to Turbine Interference Check
^
Stator to Impeller Interference Check
^
Torque Converter Leak Check
^
Evidence of transmission assembly or fluid contamination is found due to the following transaxle or converter failure modes:
^
major metallic failure
^
multiple clutches or clutch plate failures
^
sufficient component wear which results in metallic contamination
