Sable V6-3.0L VIN U (1999)
Remove the front axle wheel hub retainer and washer.
5. For SHO only, remove wiring harness from routing clip on front shock absorber. Remove air suspension height sensor from height sensor ball
studs. Position air suspension height sensor out of way.
6. Remove the front brake anti-lock sensor wire harness from the wire harness retaining clip.
7. Remove the front brake anti-lock sensor and position aside.
8. Remove and discard front suspension lower arm-to-ball joint nut.
9. Using Ball Joint Tool 211-S200 (T96P-3010-A1), Tie-Rod Remover Adapter 211-087 (T81 P-3504-W) and Steering Arm Remover 211-003
(T64P-3590-F), press lower ball joint from front suspension lower arm.
10. Separate front suspension lower arm from lower ball joint.
11. CAUTION: Never use a hammer to separate the front wheel driveshaft joint from the hub. Damage to the front wheel driveshaft joint threads and
internal components can result.
Install Front Hub Tool 204-069 (T81P-1104-C), Hub Adapter 205-237 (T86P-1104-A1), Metric Hub Remover Set 204-085 (T83P-1104-BH) and
Installing Adapter 204-067 (T81P-1104-A).
