Sable AWD V6-3.5L (2008)
7. Disconnect the window motor electrical connector, then position the wiring harness aside.
-
Disconnect the 4 wiring harness retainers and the grommet.
-
Push the grommet through the opening and into the door panel.
8. Remove the interior door handle bolt, and position the door handle aside.
-
To install, tighten to 7 Nm (62 lb-in).
9. NOTE: If the window regulator motor is inoperative, remove it.
Lower the window until the glass clamp bolts can be accessed through the rear access hole and front door speaker opening.
10. Loosen the B-pillar front door window glass clamp bolt.
-
To install, tighten to 8 Nm (71 lb-in).
