Sable AWD V6-3.5L (2008)
7. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.
Programming the Auto-Unlock Feature Using the Keyless Entry Keypad
NOTE:
-
The auto-unlock feature can be activated or deactivated independently of the autolock feature.
-
The auto-unlock feature of the SJB can also be configured ON or OFF with the scan tool.
1. Turn the ignition key to the OFF position and close all vehicle doors.
2. Enter the factory set 5-digit keyless entry keypad code.
3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button,
press and release the 7/8 button a second time.
4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
Programming the Auto-Unlock Feature Using the Instrument Cluster Message Center
NOTE:
-
The auto-unlock feature can be activated or deactivated independently of the autolock feature.
-
The auto-unlock feature of the SJB can also be configured ON or OFF with the scan tool.
1. Turn the ignition key from the OFF to the ON position.
2. Press the SETUP button on the message center switch until AUTOUNLOCK <ON> OFF is displayed.
3. Press the RESET button to select ON or OFF. If auto-unlock is enabled, the message center will have brackets around the <ON> display. If
auto-unlock is disabled, the message center will have brackets around the <OFF> display.
