Sable AWD V6-3.5L (2008)
Opening Panel Motor Initialization. See: Testing and Inspection/Programming and Relearning
1. Open the roof opening panel to the VENT position.
2. Remove the 4 roof opening panel glass screws.
-
To access the glass screws, unclip the top portion of the concertina blind and position aside as shown.
-
To install, tighten to 4 Nm (35 lb-in) and make sure concertina blind is clipped correctly back in place.
3. From the outside of the vehicle, remove the roof opening panel glass assembly.
4. To install, reverse the removal procedure.
-
Check for correct alignment of the roof opening panel. For additional information, refer to Roof Opening Panel Alignment. See:
Adjustments/Roof Opening Panel Alignment
5. Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization. See: Testing and
Inspection/Programming and Relearning
