Sable AWD V6-3.5L (2008)
Using a 5 mm (3/16 in) drill, remove the 2 rivets and the OCSM from the seat cushion frame bracket.
Seats with an OCS system service kit
11. NOTE: Make note of the opening that the OCS system service kit components are being fed through on the seat cushion support assembly for
installation purposes.
Remove the OCS system service kit from the seat cushion frame.
-
Remove any tie straps securing wire harnesses or electrical connectors.
-
Feed the hose, pressure sensor, wire harness, electrical connector and OCSM through the seat cushion frame support assembly.
Heated seats
12. Remove the rivet, tip the heated seat module and slide the retainers out of the cushion frame bracket, disconnect and remove the heated seat
module.
Seats with power recline
13. Disconnect the power recliner motor electrical connector.
14. Drive out the 2 large roll pins.
15. Remove the 3 bolts and the power recliner motor assembly.
Vehicles with manual recline seats
16. Drive out the 2 large roll pins and remove the manual recliner.
All vehicles
17. Remove the seat wire harness.
18. Remove the hog rings and cushion trim cover.