Sable AWD V6-3.5L (2008)
^
To install, tighten to 25 Nm (18 lb-ft).
11. Remove the upper 2 brake pedal bracket bolts from the brake pedal bracket assembly.
^
To install, tighten to 25 Nm (18 lb-ft).
12. Disconnect the vehicle electrical harness locators and remove the brake pedal bracket assembly from the vehicle.
13. CAUTION: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
To install, reverse the removal procedure.
