Sable AWD V6-3.5L (2008)
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor bolt.
^
To install, tighten to 8 Nm (71 lb-in).
LH
4. Release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
5. Release the wheel speed sensor harness pin-type retainer and remove the wheel speed sensor.
RH
6. Release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
7. Release the 3 pin-type retainers and remove the wheel speed sensor.