Sable AWD V6-3.5L (2008)
Catalytic Converter: Service and Repair
Catalytic Converter - RH
Catalytic Converter - RH
1. NOTE: If necessary, the catalytic converter heat shield can be serviced separately.
NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the exhaust Y-pipe.
3. Remove the RH catalyst monitor sensor.
4. Remove the 2 bracket-to-RH catalytic converter bolts.
^
To install, tighten to 20 Nm (15 lb-ft).
5. Remove the 4 nuts and the RH catalytic converter.
^
Discard the 4 RH catalytic converter nuts and gasket.
^
To install, tighten to 40 Nm (30 lb-ft).
6. Remove and discard the 4 RH catalytic converter-to-exhaust manifold studs.
^
To install, tighten to 25 Nm (18 lb-ft).
7. To install, reverse the removal procedure.
^
Install a new gasket, nuts and studs.
