Sable AWD V6-3.5L (2008)
9. Remove the secondary safety belt guide from the B-pillar.
10. Remove the D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
11. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
Position aside the scuff plate trim panel and remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
12. Remove the safety belt retractor.
-
Unhook the safety belt retractor.
-
Disconnect the safety belt retractor electrical connector.
13. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
14. Repower the SRS.
15. Check the active restraint system for correct operation.
