Sable AWD V6-3.5L (2008)
Using a suitable spring compressor, slightly compress the spring to remove initial tension. While holding the strut rod, loosen the nut. Continue to
compress the spring until tension is relieved.
3. While holding the strut rod, remove and discard the strut rod nut.
^
To install, tighten to 80 Nm (59 lb-ft).
4. Inspect the upper strut mount and seat-bearing assembly. The spring insulator should not be cracked, torn or distorted. The strut bearing should
turn freely without grinding. Install a new strut and spring assembly mount, if necessary.
^
To install, tighten to 80 Nm (59 lb-ft).
5. Decompress and remove the spring. Remove the dust boot and jounce bumper.
^
To maintain wheel camber:
-
position the notch and arrow on the upper strut mount outboard opposite the locator tab on the strut.
^
To adjust camber +0.5 degrees:
-
position the notch and arrow on the upper strut mount inboard aligned with the locator tab on the strut.
