mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

All Other Service Bulletins for Fuel Injector:|852216 > < Fuel System - Injector Tester/Cleaner Service Tips
Page 1
background image

Fuel Injector: All Technical Service Bulletins
Fuel Injector - Internal Leakage/Exhaust Smoke

Article No. 86-17-9

FUEL INJECTOR - INTERNAL FUEL LEAK - 2.3L CFI/2.5L CFI

IDLE - LOADING - INTERNAL FUEL LEAK - 2.3L CFI/2.5L CFI

LOADING-BLACK SMOKE ON

ACCEL -INTERNAL FUEL LEAK - 2.3L CFI/2.5L CFI

FORD 1985-86 TEMPO; 1986 TAURUS

LINCOLN-MERCURY 1985-86 TOPAZ; 1986 SABLE

An internal fuel leak can be caused by the fuel injector lower O-ring being damaged or incorrectly seated in the throttle body. This may cause the vehicle
to run rich resulting in a failed emission test and/or unnecessary replacement of CFI or EEC IV service components.

To correct this, use the following diagnostic/repair procedure.

1.

Perform Steps 1 through 4 of TSB 85-14-14 for vacuum bleed down system check.

2.

Determine by leak down test that a fuel leak is present. (Fuel pressure must remain at 14.5 +/- 1.5 psi for 60 seconds.)

3.

If the fuel pressure does not hold as specified in Step 2, remove injector and replace lower O-ring E53Z-9229-B.

NOTE:

Refer to TSB 86-13-15 for proper injector removal and replacement procedure.

4.

Verify that the fuel leak has been corrected by repeating Step 2. If the fuel leak has not been corrected, replace the injector and repeat Step 2 to
verify the correction.

PART NUMBER

PART NAME

CLASS

E53Z-9229-B

O-ring

B

OTHER APPLICABLE ARTICLES: 85-14-14, 86-13-15
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP9593A86
TIME:

1.3 Hr. DLR. CODING: Basic Part No. 9F593 - Code: T6

All Other Service Bulletins for Fuel Injector:|852216 > < Fuel System - Injector Tester/Cleaner Service Tips