Topaz L4-140 2.3L CFI (1985)
Figure 23 - Distributor with Push On Rotor
14.
If the distributor uses a push-on rotor, place a 1/2 inch deep well socket over the shaft (Figure 23), invert and place on arbor plate.
Figure 24 - Distributor with Screw-Down Motor
14a. If the distributor uses a screw-down rotor, invert and place on arbor plate (Figure 24).
15.
Place the distributor gear on the shaft and line up the mark on the armature and gear.
NOTE:
The hole in the shaft and gear must be lined up as accurately as possible to assure ease of roll pin insertion.