Topaz L4-140 2.3L HSC (1984)
Figure 19
Correction:
Pull flocked run out of the corner of door frame and install a piece of 1/8"x7/8"x2" long foam tape as shown in Figure 19.
Group III Rear Doors Tempo/Topaz
1.
Concern: A gap exists between the belt moulding and the door at front of rear door.
Figure 20
Correction:
Remove belt moulding and apply two layers of 1/4"x3/4"x6" long foam tape to the underside of the belt moulding as shown in Figure
20.
2.
Concern: Early built units did not include a foam gasket behind the sail cover area on low series vehicles.
NOTE:
On low series vehicles the sail cover is an integral part of the door trim panel.