Topaz L4-140 2.3L HSC (1984)
FIGURE 2 - Plastic Identification Tag
Springs installed at vehicle assembly have a plastic identification tape tag (Figure 2).
The load indicated on the spring tag is a nominal load to obtain a predetermined check height. The spring, however is designed to operate over a range of
loads. The rate is the weight required to compress the spring one millimeter or one inch. Under no circumstances, except where specified, should springs
of unequal rates be used together as pairs (side-to-side). Spring pairs however will be of different rates front to rear.
WARRANTY STATUS: "INFORMATION ONLY"
1984-1985 CROWN VICTORIA/GRAND MARQUIS FRONT SPRING CHART
1984-1985 CROWN VICTORIA/GRAND MARQUIS REAR SPRING CHART