Topaz AWD L4-140 2.3L HSO (VIN S) (1988)
/Page-381007.png)
10.
Connect fuel supply and return lines to electrical connectors.
11.
Install vacuum lines.
12.
Install air cleaner assembly and heat shroud assembly.
13.
Install accelerator cable.
14.
Install speed control cable, if so equipped.
15.
Connect battery ground cable.
16.
Fill cooling system, 17. Start engine and check for leaks.
Pages 21-10-4, 21-10-5 & 21-10-5A
1986-89
21-10-4
Engine, 2.5L
21-10-4
REMOVAL AND INSTALLATION (Continued)
19.
Remove air cleaner-to-canister hose.
20.
Raise vehicle on hoist.
21.
Drain engine oil.
22.
Remove engine oil filter.
23.
Disconnect starter cable and remove starter motor.
24.
ATX only: Remove converter nuts and position mark, made previously, on crankshaft pulley as close to 6 o'clock position (BDC) as possible with
converter stud visible.
NOTE:
The flywheel timing marker must be in a 6 o'clock (BDC) position for proper engine removal and installation.
25.
Remove engine insulator nuts.
26.
Disconnect exhaust pipe from manifold.
27.
Disconnect canister bracket from engine.
28.
Disconnect halfshaft bracket from engine.
29.
Remove lower engine-to-transaxle attaching bolts.
30.
Disconnect lower radiator hose at tube.
31.
Lower hoist and vehicle.
32.
Position floor jack under transaxle.
33.
Disconnect power steering lines at pump.
34.
Install Engine Lifting Eyes D81L-6001-D and Engine Support Tool D87L-6000-A or an equivalent.
35.
Attach lifting equipment to support engine and remove upper engine-to-transaxle attaching bolts.
36.
Remove engine from vehicle.
37.
Mount on stand and remove lifting equipment.
Installation
1.
Install Engine Lifting Eyes D81L-6001-D and Engine Support Tool D87L-6000-A or equivalent, and attaching lifting equipment.
NOTE:
The flywheel timing marker must be in a 6 o'clock (BDC) position for proper engine removal and installation (ATX only).
2.
Remove engine from stand and position in vehicle.
3.
Remove lifting equipment and lifting eyes.
