Topaz FWD L4-140 2.3L HSC (VIN X) (1989)
/Page-1070002.png)
Removing And Installing Clutch Spring
5. Using a bench vise, clutch spring compressor tool No. T81P-70222-A, and clutch spring compressor extension tool No. T80L-77515-A or
equivalent, remove piston retaining ring.
6. Remove retaining ring and piston return spring retainer.
7. Remove clutch piston using pliers.
8. Remove piston seal from intermediate clutch cylinder.
9. Remove seal from clutch piston.
ASSEMBLE
1. Inspect piston check ball. Ensure ball is present and free in cage.
2. Install seal on piston.
3. Install piston seal in clutch cylinder.
4. Apply light film of petroleum jelly to piston seals, clutch cylinder seal area, and clutch piston inner seal area, then install clutch piston.
5. Position piston return spring retainer and piston retaining ring.
6. Install piston retaining ring using a bench vise, clutch spring compressor tool No. T81P-70222-A and clutch spring compressor extension tool No.
T80L-77515-A or equivalent, as shown in the Removing And Installing Clutch Spring image.
7. Install seal rings on clutch cylinder hub.
8. Install wave spring, clutch pack, and pressure plate.
9. Install clutch pack retaining ring.
10. Check clearance between clutch retaining ring and pressure plate is as follows:
