Topaz FWD L4-140 2.3L HSC (VIN X) (1989)
/Page-1133005.png)
3. Carefully align splines of outboard CV joint stub shaft with splines in hub and push the shaft into the hub as far as possible.
Use Front Hub Remover/Replacer T81P-1104-C and Front Hub Installer T81P-1104-A and Metric Hub Remover Adapters T83P-1104-BH or
equivalent to complete the installation.
CAUTION: The center thread of Front Hub Remover/Replacer T81P-1104-C or equivalent must be oiled before installation and tightening.
Failure to lubricate the threads could result in an inaccurate torque wrench reading.
4. Connect control arm to steering knuckle and install a new nut and bolt.
5. Tighten nut to 54-74 N.m (40-54 lb-ft).
CAUTION: A new bolt and nut must be installed.
6. Position brake hose routing clip on suspension strut and install retaining bolt.
7. Tighten bolt to 11 N.m (8 lb-ft).
