Topaz FWD L4-140 2.3L HSC (VIN X) (1989)
Fig. 7 Halfshaft Assembled Lengths
6.
Remove all excess grease from external surfaces of constant velocity joint, then position boot over constant velocity joint and move joint in or out
to adjust to proper length, Fig. 7.
7.
Before installing boot clamp, insert dulled screwdriver blade between boot and outer bearing race to allow trapped air to escape.
8.
Ensure that boot is seated in groove, then install clamp securely but not too tight.
Inboard Constant Velocity Joint & Boot, 5 Speed Manual Transmission
Fig. 8 Interconnecting Shaft. 1989-90