Topaz FWD L4-140 2.3L HSO (VIN S) (1988)
/Page-367002.png)
5.
Raise vehicle.
6.
Install stabilizer bar brackets to body and tighten to 63-72 Nm (47-55 ft lb).
7.
Lower vehicle.
8.
Install idler pulley bracket.
9.
Install idler pulley.
10.
Install engine mount and tighten the nut and bolts to the engine bracket to 80-120 Nm (60-90 ft lb). Tighten the bolts to the body to 50-75 Nm
(40-55 ft lb). Tighten the nuts to the body to 100-135 Nm (75-100 ft lb).
11.
Install belt tensioner.
12.
Remove engine support bar.
13.
Install fuel line shield.
14.
Install drive belt(s).
15.
Connect battery ground cable.
