Topaz FWD L4-140 2.3L HSO (VIN S) (1988)
/Page-1076001.png)
Band Apply Servo: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect electrical connectors from fan motor and temperature sending unit.
3. Disconnect FM capacitor wiring, if equipped.
4. Remove two fan shroud to radiator attaching nuts, then fan and fan shroud.
5. Remove filler tube to case attaching bolt, then rotate the filler tube and dipstick.
NOTE: Do not remove tube from case.
6. Remove lower left side front mount to case attaching bolt.
7. Remove servo cap and snap ring with snap ring removal tool No. T81P-70027A or equivalent.
INSTALLATION
1. Reverse procedure to install.
