Topaz FWD L4-140 2.3L HSO (VIN S) (1988)
/Page-1085003.png)
Checking Clutch Pack Clearance
a. Push downward on clutch pack with at least ten pounds of pressure. Release pressure, then zero dial indicator tool No. TOOL-4201-C or
equivalent.
b. Lift pressure plate to bottom of retaining ring. Note dial indicator reading then take another reading 180° apart and use average.
c. The clearance should be 0.030-0.055 inches for the reverse clutch and 0.030-0.044 inches for the three intermediate clutch plates.
d. If clearance is not satisfactory, selective snap rings are available for the intermediate clutch in the following thicknesses; 0.049-0.053 inch,
0.059-0.063 inch, and 0.070-0.074 inch. Reverse clutch snap rings are available in the following thicknesses; 0.049-0.053 inch, 0.066-0.070
inch, 0.083-0.087 inch, and 0.099-0.103 inch.
11. Install correct snap ring and recheck clearance.
12. If removed, install stop ring on intermediate shaft, then install intermediate shaft into clutch cylinder.
13. Install intermediate shaft retaining ring.
