Tracer L4-110 1.8L DOHC (1995)
Front Shock/Strut Assembly
WARNING: ALWAYS WEAR SAFETY GOGGLES WHEN USING A SPRING COMPRESSOR.
4. Install an appropriate spring compressor onto the shock/strut spring.
5. Compress the spring.
Front Shock/Strut Assembly
6. Remove the nut, mounting block, thrust bearing, upper spring seat, rubber spring seat, coil spring and bound stopper.
Assembly
Front Shock/Strut Assembly-Assembly
1. Position the bound stopper onto the shock/strut piston rod.
2. With the coil spring compressed, position the spring onto the shock/strut assembly.
3. Install the rubber spring seat, upper spring seat, thrust bearing, mounting block and piston rod nut. Tighten the piston rod nut to 79-110 N.m
(58-81 lb-ft).
4. With the nut tightened to the specification, carefully remove the spring compressor from the spring while making sure the spring is properly
seated in the upper and lower spring seats.