mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Door Lock Controller - Sticks In the Up/Down Position|Page 55 > < Code 91 - 100, ( 92 93 94 95 96 97 98 99 )|System Diagnosis|Page 44
Page 1
background image

Power Door Lock Control Module: All Technical Service Bulletins
Door Lock Controller - Sticks In the Up/Down Position

Article No. 
92-15-2

07/15/92

LOCKS - POWER DOOR - CONTROLLER STICKS IN UP OR DOWN POSITION - VEHICLES BUILT BEFORE 12/1/90

FORD:
1991 ESCORT

LINCOLN-MERCURY: 
1991 TRACER

ISSUE:
The power door lock controller may stick in the up or down position. This occurs because of the internal components in the original door lock
controllers.

ACTION:
Check the operation of the power door lock controller. If it sticks, replace it with an improved door lock controller. Refer to the following procedure for
service details.

1.

Confirm that the door lock controller is sticking.

2.

Remove the sticking door lock controller. Refer to the 1991 Escort/Tracer Service Manual, Section 01-14, for the removal procedure.

3.

Check the build date code on the controller, Figure 1.

4.

Check the internal door linkages. Make sure they are not binding and are properly lubricated.

5.

If the power door lock is still sticking and the controller was built within the specified build dates, replace the door controller.

NOTE:
USE CONTROLLERS MARKED "11KI" OR LATER. CHECK THE PARTS STOCK TO MAKE SURE THAT EARLIER BUILT CONTROLLERS
ARE NOT INSTALLED.

PART NUMBER

PART NAME

CLASS

F1CZ-58218A42-A

Right Front Door Lock

C

Controller

Door Lock Controller - Sticks In the Up/Down Position|Page 55 > < Code 91 - 100, ( 92 93 94 95 96 97 98 99 )|System Diagnosis|Page 44