Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
4.
Rotate the rear body side door latch actuating rod clockwise. Doing this will lengthen the outside door handle unlatch stroke (Figure 2).
NOTE
THE LENGTH OF THE ACTUATING ROD NEEDS TO BE ADJUSTED SO THE BODY SIDE DOOR REAR LATCH RELEASES WHEN
THE OUTSIDE DOOR HANDLE IS BETWEEN 3/4 AND FULL TRAVEL.
5.
Position the rear body side latch actuating rod into the yellow lock clip.
6.
Verify that the body side door rear latch releases after reaching 3/4 travel of the outside door handle. If adjustment is still needed, repeat the
adjustment procedure as necessary until the proper body side door rear latch operation is achieved.
7.
When adjustment is completed, verify that the INSIDE door handle releases the body side rear latch correctly.
8.
Attach the plastic weather shield to the body side door.
9.
Reinstall the body side door trim panel and bezel. Refer to Villager Workshop Manual Section 01-05.
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 111000,112000, 702000, 702300
