Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
6. Push the front brake anti-lock sensor cable grommet through the wheel well.
7. Disconnect the front brake anti-lock sensor electrical connector in the engine compartment and pull the harness retainer from the body.
8. Remove the front brake anti-lock sensor from the vehicle.
INSTALLATION
1. Position the front brake anti-lock sensor in the vehicle. Attach it with the harness retainer in the engine compartment.
2. Connect the front brake anti-lock sensor electrical connector.
3. Install the front brake anti-lock sensor cable grommet in the wheel well.
4. Position the front brake anti-lock sensor cable on the wheel well and install the two front brake anti-lock sensor cable bracket-to-wheel well
screws.
5. Position the two front brake anti-lock sensor cable brackets on the strut. Install the two front brake anti-lock sensor cable bracket bolts.
6. Position the front brake anti-lock sensor on the front wheel knuckle and install the brake anti-lock sensor bolt. Tighten the brake anti-lock sensor
bolt to 11-15 Nm (124-133 inch lbs.).
CAUTION: Do not force or use any tool to force the front brake anti-lock sensor into the mounting hole.
7. Install the front wheel and tire assembly. Tighten the lug nuts to 98-118 Nm (78-87 ft. lbs.).
8. Lower the vehicle.
