Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Wheel Hub: Service and Repair
Front
Removal
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the disc brake caliper and suspend it with mechanic's wire out of the way.
NOTE: It is not necessary to disconnect the front brake hose.
4. Remove the front disc brake rotor.
5. Remove and discard the cotter pin.
6. Remove the front axle wheel hub retainer and the front wheel outer bearing retainer washer.
7. Remove and discard the cotter pin from the front suspension lower arm ball joint.
8. Loosen the front suspension lower arm ball joint nut until it contacts the front wheel driveshaft joint.