Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
5. Remove the accelerator cable bracket.
INSTALLATION
1. Position the accelerator cable bracket on the intake manifold and install the accelerator cable bracket bolts.
2. Install the accelerator cable and speed control actuator cable, if equipped, on the accelerator cable bracket. Tighten the accelerator cable locknut
and, if equipped, the speed control actuator locknut to 8-11 Nm (71-97 in lb).
3. Install the accelerator cable and the speed control actuator cable, if equipped, on the throttle lever.
4. Adjust the accelerator cable.
5. Adjust the speed control actuator cable, if equipped.
