Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Power Transistor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the power transistor electrical connector.
3. Remove the power transistor bracket-to-cylinder head bolt.
4. Remove the power transistor with the bracket attached.
5. Remove the two power transistor-to-bracket bolts.
6. Remove the power transistor.
INSTALLATION
To install, reverse the removal procedure.
-
Tighten the power transistor-to-bracket bolts to: 3 Nm (26 in lb).
-
Tighten the bracket-to-cylinder head bolt to: 13 Nm (9 ft lb)
