mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Air Bag System - Lamp Flashes/No Codes in Memory|Page 331 > < Air Bag System - Lamp Flashes/No Codes in Memory|Page 329
Page 1
background image

Air Bag Control Module: Description and Operation

WARNING:  The backup power supply energy must be depleted before any air bag component service is performed. To deplete the backup
power supply energy, disconnect the battery ground cable and wait ten minutes.
 

PURPOSE

The air bag diagnostic monitor continually monitors all Supplemental Restraint System (SRS) components and wiring connections for possible faults
in the system. 

 

OPERATION

If the diagnostic monitor detects a fault in the SRS when the ignition switch is in the ON or START position, the air bag warning indicator, located in
the instrument cluster will flash continuously or remain illuminated. If the system is operational, the air bag warning indicator will illuminate for about
seven seconds and then turn off. 

FEATURES and FUNCTIONS 

-

The air bag diagnostic monitor illuminates the air bag warning indicator for approximately seven seconds when the ignition switch is in the ON or
START position, then turns the air bag warning indicator off. This shows that the air bag system is operational. If the air bag warning indicator
does not illuminate or the air bag warning indicator stays on or flashes at any time, a fault has been detected by the air bag diagnostic monitor. 

-

If a fault code is detected, the air bag warning indicator will begin to flash after seven seconds when the ignition switch is in the ON position. 

-

If the air bag diagnostic monitor is malfunctioning, the air bag warning indicator will remain illuminated. 

-

The air bag diagnostic monitor includes an internal backup power supply. This feature provides sufficient backup power to deploy the air bag in
the event that the battery or battery cables are damaged in an accident before the primary crash air bag sensor and the safing air bag sensor close.
The backup power supply will deplete its stored energy approximately ten minutes after the battery ground cable is disconnected. 

-

The primary crash air bag sensor and the safing air bag sensor are incorporated into the air bag diagnostic monitor. 

Air Bag System - Lamp Flashes/No Codes in Memory|Page 331 > < Air Bag System - Lamp Flashes/No Codes in Memory|Page 329