Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Power Steering Pump: Service and Repair
Power Steering Pump
Removal and Installation
REMOVAL
1. Disconnect the battery ground cable (14301).
2. Raise and support the vehicle.
3. Remove the power steering pump pulley (3A733). See: Power Steering Pump Pulley
4. Place a drain pan under the power steering pump (3A674).
5. Remove the power steering pressure hose bolt from the power steering pump. Place the power steering pressure hose (3A719) up and out of the
way.
6. Remove the two power steering reservoir pump hose bolts. Place the power steering reservoir pump hose up and out of the way.
7. Remove the three front power steering pump bolts.
8. Remove the rear power steering pump bolt.
