Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
7. Install the tie rod end nut. Tighten the tie rod end nut to 29-39 Nm (22-29 ft. lbs.).
NOTE: If the slots in the tie rod end nut do not align with the hole in the tie rod end stud, tighten the tie rod end nut for proper alignment. Never
loosen the tie rod end nut.
8. Install a new cotter pin.
9. Insert the front suspension lower arm ball joint stud partially through the front wheel knuckle. Start the front suspension lower arm ball joint nut on
the stud.
10. Push the front suspension lower arm bail joint completely into the front wheel knuckle. Tighten the front suspension lower arm ball joint nut to
71-86 Nm (52-63 ft. lbs.).
11. Install the new cotter pin in the front suspension lower arm ball joint.
12. Install the front wheel outer bearing retainer washer.
