Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Torque Converter: Testing and Inspection
Boss Bushing
The torque converter is welded together and cannot be disassembled.
1. Check the torque converter for damage or cracks and replace, if necessary.
2. Inspect for damage, breakage or rough areas on the inside bushing. Make sure the bushing size is within specification. If the bushing is not within
specification, replace the torque converter.
3. Remove any rust from the pilot hub and boss of the torque converter.
4. Measure the inner diameter of the boss bushing. If it exceeds 53.075 mm (2.0896 inch), replace the torque converter.
