Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Power Window Control Module: Service and Repair
Power Window Amplifier
REMOVAL
NOTE: The power window amplifier is located between the LH front door trim panel and the watershield on the LH front door.
1. Disconnect the battery ground cable.
2. Remove the LH front door trim panel.
3. Disconnect the power window amplifier electrical connector.
4. Remove the two power window amplifier screws.
5. Remove the power window amplifier from the vehicle.
INSTALLATION
1. To install, reverse the removal procedure.