Villager V6-201 3.3L SOHC VIN T SFI (1999)
10.
Lift and rotate the seat track to access and disconnect the E-Z entry cable from the seat track. See Figure 4.
11.
Connect the E-Z entry cable to the new seat track. Make sure the E-Z entry cable is in the plastic guide. See Figure 5.
12.
Connect the seat track adjusting wire to the seat tracks. See Figure 3.
13.
Install the rear seat track-to-cushion bolt. Tighten the bolt to 23 Nm (17 lb-ft). See Figure 2.
14.
Slide the seat track all the way rearward and install the front seat track-to-cushion bolt. See Figure 1. Tighten the bolt to 23 Nm (17 lb-ft).
15.
Install a new safety belt buckle bolt and wave washer. Be sure to remove the shipping retainer before installing the bolt. Tighten the bolt to 40 Nm
(30 lb-ft).
16.
Install the side cover and the three (3) screws.
17.
Install the seat frame and the five (5) retaining nuts. Tighten the nuts to 23 Nm (17 lb-ft). See Figure 1.
18.
Install the track assisting spring. See Figure 1.