Villager V6-201 3.3L SOHC VIN T SFI (1999)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Partially drain the coolant.
3. Disconnect the ECT sensor electrical connector.
4. Remove the ECT sensor.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: If the engine coolant temperature sensor is reused, apply pipe sealant with Teflon(R) meeting Ford specification WSK-M2G350-A2 and
ESR-M18P7-A to the threads.