Villager V6-201 3.3L SOHC VIN T SFI (1999)
6.
Disconnect the two empty hard shells from the jumper harness and remove locking wedges (Figure 4).
7.
Insert the Blue/Yellow jumper harness wire (female end) into pin location 9 on the engine harness side of C149 (Figure 3).
8.
Use Silicone Brake Caliper Grease and Dielectric Compound XG-3-A or equivalent to seal the empty pin location 30 on the back of C149.
9.
Re-install the two (2) red terminal retainers into the front of C149.
10.
Insert the larger Blue/Yellow engine harness wire into the large hard shell connector, verify pin location/orientation and install locking wedge
(Figure 5).
11.
Insert the smaller Yellow wire into the small hard shell connector, verify pin location/orientation and insert locking wedge (Figure 5).
