Villager V6-201 3.3L SOHC VIN T SFI (1999)
Throttle Position Sensor: Adjustments
New Generation Star Tester
Special Tool(s)
1. Connect the New Generation STAR (NGS) Tester to the fuse panel Data Link Connector (DLC).
2. Turn the ignition switch to the ON position.
3. Configure the NGS with the correct year, vehicle, and mode.
4. Measure the Throttle Position (TP) sensor voltage with the throttle valve completely closed.
5. Loosen the TP sensor screws and adjust the TP sensor to a reading of O.3V - O.7V.
6. Tighten the TP sensor screws.
7. Make sure that the idle position switch PID reads ON.
8. Run the vehicle until it reaches operating temperature turn off vehicle.
9. Turn the ignition ON 5 seconds and OFF for 5 second. Repeat 20 times.
