Villager V6-201 3.3L SOHC VIN T SFI (1999)
Evaporative Vapor Pressure Sensor: Service and Repair
REMOVAL
1. Raise and support the vehicle.
WARNING: DO NOT SMOKE, CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR
NEAR ANY FUEL-RELATED COMPONENT. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE
IGNITED, RESULTING IN POSSIBLE PERSONAL INJURY.
2. Remove the EVAP emissions canister shield.
1
Remove the push pins.
2
Remove the bolts.
3
Remove the screws.
3. Remove the EVAP canister bracket screws.
4. Remove the EVAP canister pressure sensor.
1
Remove the EVAP canister pressure sensor purge line.
2
Disconnect the EVAP canister pressure sensor electrical connector.
3
Remove the EVAP canister pressure sensor bolts.
INSTALLATION