Villager V6-201 3.3L SOHC VIN T SFI (1999)
Headlamp Dimmer Switch: Component Tests and General Diagnostics
Ignition Switch Mechanical Test
IGNITION SWITCH MECHANICAL TEST
Inspect the ignition switch and the ignition switch lock cylinder for signs of binding. If there are signs of binding, repair or install a new ignition
switch or ignition switch lock cylinder as necessary.
NOTE: Do not apply lubricant to the inside of the ignition switch.
NOTE: If a binding condition occurs, turn the steering wheel left or right to release the possible load on the steering wheel. Also, verify that the
ignition key is cut properly.
Switch Electrical Test
Component Testing Instructions
Component testing procedures are provided to determine whether a component is good or bad.
Testing information for each component includes a schematic with component terminal locations and step-by-step test procedures. Component
terminals are identified by letters or numbers that may be marked on the component or call out if there is no mark on the component.
The component connector MUST BE REMOVED before testing. To test a single circuit within the component, select that circuit under the column
TO TEST. If you wish to test the complete component, perform all tests.
