Villager V6-201 3.3L SOHC VIN T SFI (1999)
Power Window Switch: All Technical Service Bulletins
Power Door Locks - Self Activation or Cycling
Article No.
00-5-6
03/06/00
POWER DOOR LOCKS - SELF-ACTIVATING OR CYCLING-VEHICLES BUILT FROM 9/26/1998 THROUGH 9/15/1999
MERCURY:
1999-2000 VILLAGER
This TSB is being republished in its entirety to correct the build dates for the switches.
ISSUE
The power door locks may self-activate or cycle on some vehicles. This may be caused by misadjustment of the front door lock linkage, excess solder in
the front door power window switch, or water infiltration of a potential open wire harness connector inside the front doors.
ACTION
Adjust the door lock rod bellcrank, replace the power window switch assembly and check for and remove a possible open wire harness connector on
both front doors. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
1.
Remove a front door trim panel by referring to the appropriate year Villager Workshop Manual, Section 501-05.
2.
Position the watershield aside.
3.
Loosen the lock rod bellcrank bolt (Figure 1).
4.
Engage the front door latch into the closed position by closing the door or by manually closing the latch.
5.
Manually lock the front door latch with the actuating rod.
