Villager V6-201 3.3L SOHC VIN T SFI (1999)
12.
Install a zip tie around the wiring harness and door glass run bracket to secure it away from the door check strap area (DO NOT
OVERTIGHTEN), and trim off the excess tie strap (Figure 6).
13.
Reinstall watershield and door trim panel.
14.
Repeat above Steps on the opposite front door.
15.
If the vehicle was built between 9/28/98 and 4/1/01, use a coin or comparable tool to open the key fobs. Inspect the back side of the unlock and
panic buttons for the "positive stops" (Figure 7). If the positive stops" are not present as shown for the new style key fob in Figure 7, replace the
key fobs.
